Technics SC-CH510 User Manual

Problem Probable cause(s) Suggested remedy
When
there
is
a
television
set
nearby
The
picture
on
the
TV
The
location
and
orientation
of
the
antenna
are
\f
you
are
using
an
indoor
antenna,
change
to
an
disappears or stripes incorrect. outdoor antenna.
appear on the screen. The wiring at the back of the system is unsuitable. | Separate the antenna wire of the TV set from the
system.
While listening to tapes
Sound is low, Heads are dirty. Clean the heads.
intermittent,or poor quality, Dolby noi ae ions is set in th a
nolsy, scratchy, or Dolby noise reductions is set in the wrong position.
unsteady.
Set it to match the Dolby NR recording mode.
The deck does not enter
the recording mode.
DOLBY NR indicators and
REVERSE MODE indicators
begin to flash
simultaneously, and the
cassette deck become
tneapable of operation.
While listening to compact discs
The display will not show The disc is not positioned correctly in the disc tray.
the correct indication. Disc The disc is loaded upside down.
play does not start when
The disc is dirty.
you press the play button.
The disc is scratched.
The erase-prevention tabs are removed from the
Attach tape to cover the space left by removal of the
cassette.
erasé-prevention tabs.
Maifunction might occur in the cassette deck Contact with your deater or an Authorized Service
section. Center.
Load the disc on the tray correctly.
Reload the disc.
Wipe the disc with a soft cloth.
Replace the disc with a new one.
The disc is badly warped.
The disc is a nonstandard one.
There is condensation inside the compact disc
player.
Replace the disc with a different one.
Switch the power ON, and then wait for 60 minutes
before using the compact disc player.
While using the remote control
The system cannot be The batteries are installed in the reverse polarity. Re-insert the batteries in the correct polarity.
The batteries are worn. Replace the batteries with new batteries.
operated with the remote
control.
The servicer will require all components to service your system.
Therefore, should service ever be necessary, be sure to bring the entire system.
Maintenance
@ Maintenance of external surfaces - 4, Press POWER on the amplifier to ON.
To clean this unit, use a soft, dry cloth. 2. Press & OPEN to open the cassette holder.
if the surfaces are extremely dirty, use a soft cloth dipped in a 3. Press POWER on the amplifier and CLOSE at the same time.
soap-and-water
solution
or
a
weak
detergent
solution.
The
system
will
go
into
power
standby
mode
leaving
the
cassette
holder
open.
Wring
the
cloth
weil
before
wiping
the
unit.
4.
Clean
the
tape
heads,
pinch
roliers
and
the
capstan
shatts
with
a
Wipe
once
again
with
a
soft,
dry
cloth.
cotton
swab
(or
a
soft,
lint-free
cloth}
slightly
moistened
with
Never use alcohol, paint thinner, benzene, or chemically treated isopropyl alcohol.
cloths
to
clean
this
unit.
Such
chemicals
may
damage
the
finish
of
Do
not
use
any
solution
other
than
alcohol
for
head
cleaning.
your system. Pinch roller Cotton swab
@ Tape head care
To assure sound quality for recording and playback, be sure to clean
the tape heads after approximately every 10 hours of use.

Technics SC-CH510 Specifications

General

Brand	Technics
Model	SC-CH510
Category	Stereo System
Language	English