7.2. To return to the normal display
1. For U70 CD/U70 DECK
- Press an any operation button on the tuner/amplifier.
- To re-display the code, switch the power off (POWER
STANDBY button), and then switch power back on again.
2. For F61
- If F61 is displayed, the power will automatically be switched
off and the standby indicator will light up.
- F61 will be displayed for 3 seconds, and then the clock will be
displayed.
- To re-display the code, switch the power on. F61 will be re-
displayed, and then after 3 seconds the clock will be displayed
and the power will automatically switch off.
7.3. Display contents
7.3.1. U70 CD/U70 DECK / (displayed automatically)
- Problem or condition
A bus-line communications error has occurred as a result of the
flat cables being inserted incorrectly, thus preventing the system
from operating.
- If U70 is displayed on the tuner/amplifier, the tape deck or CD
Changer cannot be operated by remote control.
12
To Next Page
Loading...
