To Next PageTo Next PageWhat to do if Technics Stereo System remote control doesn't work?
If the remote control for your Technics Stereo System isn’t working, check that the batteries are inserted correctly and replace them if they are worn.
Why is there noise on my Technics Stereo System?
If you're experiencing noise, a flickering or unlit stereo indicator, distorted sound, a beat sound, a low hum during AM broadcasts, or you can’t tune into the correct AM frequency on your Technics Stereo System, try the following: * Use an outdoor antenna. * Turn the TV off or separate it from the unit. * Separate the antenna from other cables and leads. * Change the frequency step. * Hold [TUNER/BAND] down for 10 seconds to change the step to 9 kHz.
Why does the Technics Stereo System tray open automatically?
If the tray of your Technics Stereo System opens automatically, remove the disc, ensure the tray is empty, and close it. This may occur due to a problem with the disc mechanism or a power failure. The unit will make disc changing noises for a few moments and then it should operate normally.
What does “NO DISC” mean on Technics SC-DV290?
If “NO DISC” appears on the display of your Technics Stereo System, it indicates that there is no disc on the selected tray or the disc is set incorrectly.
What does “NO PLAY” mean on Technics Stereo System?
If “NO PLAY” appears on the display of your Technics Stereo System, it means the disc does not correspond to the unit and cannot be played.
General| Brand | Technics |
|---|---|
| Model | SC-DV290 |
| Category | Stereo System |
| Language | English |
Details region number 2 support for DVD-Video playback.
Details region number 4 support for DVD-Video playback.
Details region number 5 support for DVD-Video playback.
Step-by-step guide for replacing the fuse in the AC mains lead plug.
Important notes on wiring and cautions regarding unsuitable plugs.
Lists disc types supported and unsupported by the unit.
Explains disc structure and playback of DVDs, VCDs, CD-R/RW, DVD-R, DVD-RAM.
Recommendations for optimum speaker placement for surround sound.
Illustrates how to connect speaker leads to the unit and speakers, noting polarity.
Instructions for connecting video cords for different regions and televisions.
Details on connecting the AC mains lead and important notes for UK users.
Identifies and describes controls on the tuner/amplifier unit.
Identifies and describes controls on the disc changer unit.
Identifies and describes controls on the cassette deck unit.
Identifies and describes controls on the sound processor unit.
Details the functions of various buttons on the remote control.
Step-by-step instructions for setting the 24-hour clock time.
Guide to setting up language, TV type, and aspect ratio using the Quick Setup menu.
Steps for loading discs into trays and selecting the disc to play.
How to play, pause, stop, and handle discs with menus.
Instructions for skipping tracks, searching within tracks, and slow-motion playback.
How to mark and recall playback positions on discs.
Guide to selecting and playing groups of tracks or pictures from discs.
How to change audio tracks, vocal modes, and adjust sound settings.
Instructions for changing subtitle language and display options.
How to mark and recall specific points within a disc for later playback.
How to adjust zoom ratios and aspect ratios for optimal picture viewing.
How to set repeat play for programs, entire discs, or specific sections.
Instructions for A-B repeat playback and playing all groups on DVD-Audio discs.
How to select and program tracks for playback from VCDs and CDs.
Adjusting speaker levels for Dolby Digital, DTS, and Dolby Pro Logic.
How to adjust center and surround speaker delay times for optimal sound.
