Technics SC-HD510 - Page 26

Reference |
40)
RQTS296 *
000
‘BASS
“TREBLE:
(=
a |o} | Jer - 00.
22. |=} eoollle WO
000 [==] 000
FINE TWEETER
CONTROL
BLFS
or iG aeeeeeeneell
BASS TREBLE
reiedd
See eens ai 4d
A Adjusting the treble range
SC-HD510 only
Fine adjustments to the treble range can be made due to separation
of the tweeter and woofer.
Turn [FINE TWEETER CONTROL].
Turn towards MAX to emphasize the treble or towards MIN to
lessen the effect.
The effect is not noticeable through headphones.
B Adjusting the bass-BLFS
Use this feature to emphasize the bass (HIGH or LOW), or weaken
it (LIGHT).
Press [BLFS].
Each time you press the button:
BLFS HIGH —» BLFS LOW — BLFS LIGHT
_——e
To cancel
Press [BLFS] to select “FLAT.”
C To adjust the tone quality
The level can be adjusted between -3 to +3.
Press [BASS] (low-frequency sound) or
[TREBLE] (high-frequency sound).
Each time you press the button;
+1 42 43-3 +2 +1 0
eee aaa |
To cancel
Press [BASS] or [TREBLE] to select “BASS 0” or “TREBLE 0”.
(“FLAT” will light.)
D Muting the volume
Remote control only
Press [MUTING].
Volume is reduced to minimum.
To cancel
Press [MUTING] again. (“MUTING OFF” lights up.)
To cancel from the unit, turn [VOLUME] to minimum (- - dB), then
raise it to the required level.
Muting is also canceled when the unit is turned off.
If the surfaces are dirty
To clean this unit, wipe with a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth dipped in a soap-
and-water solution or a weak detergent solution.
© Never use alcohol, paint thinner or benzine to clean this unit.
© Before using chemically impregnated cloth, read the instructions
that came with the cloth carefully.
For a cleaner crisper sound
Clean the heads regularly to assure good quality playback and
recording. Use a cleaning tape (not included).