Series playback
Both sides of the tape in Deck 1 will be played, foflowed by both
sides of the tape in Deck 2. (Repeated up to eight times.)
3412
Preparation I
Load the tapes to be played into Deck 1 and Deck 2.
Note that for series playback it is not possible to select different
types of Dolby NR for Deck 1 and Deck 2, It is recommended that
you use two tapes which were recorded using the same type of
Dolby NR (or both recorded without Dolby NR).
LB;.R........ ...................................
Press DOLBY NR to select the
_ appropriate noise-reduction
system.
Press DOLBY NR to listen to
tapes recorded by Dolby B-
type noise-reduction.
_) select the _ mode.
For your reference:
It isalsopossibleto begin seriesplaybackfromthe reversesideof
the tapeinDeck I or from Deck 2, (Refer tothetapetraveltable on
page35,)
To stop playback
Press m.
To temporarily stop playback
(Only available from the remote control.)
@
I!
Press n,
Press once again to resume playback.
_H""OECKi_ ......Press DE(_I(1/2 t0seiect tile ....
{ _ Deck 1.
' "'_" .........Press k: ..............................................
(Series playback will begin from the for-
,_ ward side of the tape in Deck 1.)
36
To Next Page
Loading...
