[ To quit lhe program mode ....
[Inthestop mode]
Press PROGRAM.
The changer will return tothe sequential play mode.
I
The programmed contents will remain stored in memory until they
are cleared, even after the program mode is canceled.
Therefore, after program, it is possible to cancel the program mode
and use another play mode and then hear the same program again
at a later time.
In addition, if discs are changed, the program will be played using
the new discs. If non-existing entries are found at this time, the
changer will cancel them
For your reference ..........
The prod-am will remain stored in memory even after the unit is
switched off.
However, if the power cord is unplugged or the power supply is
otherwise interrupted for an extended length of time, the contents
will _ erased from memory.
Special note on recording programs
The changer needs time to change the discs and find the tracks.
Consequently, it will take the changer slightly longer than the total
track time to record everything. Exactly how much longer it will be
will depend on the contents of the program.
To Next Page
Loading...
