DOLBYNR
REVERSE
MODE
On the cassette deck*s display.
Type of tape which can be used for recording:
Normal position/TYPE I 0
High position/TYPE TI 0
Metal position/TYPE 1V 0
IPreparation ]
Load a tape which has been advanced to the end of the leader tape
(the transparent part at both ends of the tape) into Deck 2.
H Tum on the power of the syste_s_....
F_ Press & OPEN on Deck 2, and then Insert the_
cassette tape.
• Pushthe cassetteholderdosed by hand.
Press DOLBY NR to record by Dolby B-type noise-
reduction system.
When recording a tape without using a Dolby NR system,
press so that the indicators go off.
B Press REVERSE MODE to select the _lesired
reverse mode.
Each time the button is pressed, the indicator will change in
theorder.._r___(._,...) (_
: Only one side will be recorded, and then operation
will automatically stop. "_"
C_) • OO : Both sides (the forward side first, and then the
reverse side) wig be recorded, and then
operation will automatically stop.
B Press • REC PAUSE.
The unit will be in the recording standby mode.
B Press to select the desired source to he recording.
Press )_(or 4) to begin recording, and play the
source to be recorded.
I_: To begin recording from the forward side.
4: To begin recording from the reverse side.
• When recording on both sides of the tape, be sure to press the
I_ button.
.,--,----...--------..--------.-------------------- .----------------=--°°-------*
To stop recording
PressI.
I 'Totemporarily stop re_ording
I
Press • REC PAUSE.
"- -=IIW _=,
TO Tesuzne l"ecorcL_
Press either _ or _, corresponding to the side of the tape side
• indicator (<_ or _>) which is lit.
To Next Page
Loading...
