REVERSE
MODE
SPEED
SYNCHRO
START
1,1,1q_l...............................................[111:::_i F..........................................
Use Deck 2 to record the sound being played back on Deck 1.
[ Preparation I
Load tapes which have been advanced to the end of the leader tape
into both decks.
Deck 1: For playback Deck 2: For recording
H Press REVERSE MODE to select the desired
reverse mode.
Each time the button is pressed, the indicator will change in
the order: -_ (_4--)'-*--(_
:Only one side of the tape will be recorded, and then
operation will automatically stop.
(_) : Both sides of the tape (first the forward side and then
the reverse side) will be recorded, and then operation
will automatically stop.
If the recording tape is longer than the playback tape,
the playback tape will be played repeatedly as many
as eight Idmes until the recording tape is finished.
(_O : Both sides of the tape (first the forward side and then
the reverse side) will be recorded once, and then
operation will automatically stop.
To record on only one side of the tape, set the tape side indicators
(<_ or _>) on Deck I and _ck 2 in accordance with the tape sides to
be played back and recorded.
To record on both sides of the tape, set the tape side indicators on
both Deck I and Deck 2 to the forward side (_).
B Press SPEED to select the recording speed.
Each time the button is pressed, the indicators will change in
the order: NOR---HI-.-off.
t I
NOR: normal speed
HI: approx, double speed
Press SYNCHRO START.
Recording will begin.
,,,O,OeO,OO,tO°OHHIO*OHIH*HOJ JOOO.°°OO OOOOOOOOO0*, H.e*oH*,Ho°o°eH..eeoel
To stop recording
1. Press DECK 1/2 to select the Deck2.
2. PressII.
In order to avoid operation errors later, be sure to switch off the
SPEED button (the "NOR" and "HI" indicator will go out) after
the tape-to-tape recording has finished.
For your reference:
• The Dolby effect will be recorded as they are on the tape being
played back.
• Because the signal being recorded from Deck_onto_bck 2 does
not pass through the amplifier, it is possible tb change._e setting
of the amplifier's input selector during recording in order to listen
to some other sound source.
To Next Page
Loading...
