Technics SH-AC300

SPEAKER SETTING
CHANNEL/SET
+
SELECTOR
Q
(FRONT) | LARGE
(CENTER) | LARGE
FNE SE O 7
wer rT
| Speaker settings |
Set the types and presence (YES, NO or NONE) of the speakers before
enjoying the sound by reproducing the input source.
El Press POWER.
Press CHANNEL/SET, and select the channel
for which the speaker is to be set.
Each time the button is pressed, the channel display is switched
in the listed order.
While a channel is indicated on the display, the corresponding
speaker indicator flashes.
Press SELECTOR, and set the type and pres-
ence (YES, NO or NONE) of the speaker.
Each time the button is pressed, the display is switched in the
listed order.
4 Repeat steps 2 and 3 for each channel.
When “COMPLETE” is indicated for 2 seconds, the settings which
have been performed for all the channels are memorized, after which
the original display is restored and the speaker indicators light in
accordance with the settings (regardless of the selected reproduction
mode).
The speaker indicators for channels set to “NONE” or “NO” will go
off.
Even if the power is turned off, all settings will remain in memory
until the settings are changed.
If no buttons are pressed for more than 10 seconds during the setting
process, all previous settings are canceled, the setting mode is re-
leased, and the original display is restored.
To initiate the setting procedure again, repeat steps 2 and 3.
Type and presence settings for each speaker
Front LARGE — SMALL
Center LARGE — SMALL — NONE
Surround LARGE — SMALL — NONE
Subwoofer YES — NO
Depending on the speaker used for each channel, the deep bass range
which is hard to reproduce is assigned to the subwoofer.
O m o
When the speaker to be set is capable of
: LARGE
reproducing sound of low frequency
When the speaker to be set is not capable of
SMALL
reproducing sound of low frequency
When the center or surround speaker is not used NONE
When the subwoofer is not used
For your reference:
The benchmark for reproducing sound of low frequency is around
100 Hz.
Operation B