Technics SL-P2000

| SL-P2000 SL-P2000 |
Mi REPLACEMENT PARTS LIST
Notes: *Important safety notice:
Components identified by A mark have special characteristics important for safety.
Note: When changing loading mechanism Furthermore, special parts which have purposes of fire-retardant (resistors), high-quality sound (capacitors), low-noise (resistors), etc. are used.
parts,
apply
the
specified
grease
to
When
replacing
any
of
components,
be
sure
to
use
only
manufacturer’s
specified
parts
shown
in
the
parts
list.
the
areas
marked
“x
x”
as
shown
in
*The
parenthesized
indications
in
the
Remarks
columns
specify
the
areas.
(Refer
to
the
cover
page
for
area.)
the drawing. Parts without these indications can be used for all areas.
*Remote Control Ass’y:
Supply period for three years from termination of production.
*Warning: This product uses a taser diode. Refer to caution statements on page 3.
* ACHTUNG: Die lasereinheit nicht zerlegen.
Die lasereinheit darf nur gegen einc vom hersteller spezifizierte einheit ausgetauscht werden.
Part Name & Description Part Name & Description
SUSD145~1 FLOATING SPRING (SILVER)
RFKNP2000EGC |CLAMP PLATE ASS’ Y
RFKNP2000EBD |CLAMP PLATE ASS’ Y
SIRDS1-1 CLAMPER
SOMD4 MAGNET
SOYD2 YOKE
RFKNP2000EGE |DISC TRAY ASS’ Y
RXQ0232 SIDE PRESSURE PULLEY
RMEO074 TRAY SPRING
|RMGO193 TRAY CUSHION RUBBER
RMGO200 CUSHION RUBBER
LOADING MECHANISM
RDGO154 PULLEY GEAR
RDGO155 REDUCTION GEAR
RDKOO15-1 DRIVE CAM
REMO0026 {LOADING MOTOR ASS’ Y
SJT30444-H — |CONNECTOR (4P) (CN401)
SJT30344-H — |CONNECTOR (3P) (CN403)
RHD26002 SCREW
RHG3032ZA MOTOR CUSHION RUBBER
Racoi21 (BELT | RMRO383-1 |SHAFT HOLDER (L) |
LOADING BASE 153 RMRO412-2 SLIDE PLATE
017-1
wemues [at CAE)
POTENTION METER HOLDER REZ0338-1 [FLAT CABLE (3P) iC
RMg0299 SCREW REZ0341 ‘| FLAT CABLE (4P)
RMRO463 ROLLER | XTB3+12JF2 — |SCREW
SDOD28-2E | TURNTABLE [we0115 —_|SIDE PRESSURE SPRING
XXE26D5 ‘(SCREW
Sp0D29-2 | TURNTABLE RING PACKING MATERIALS
[Si¥D33 WASHER
SH¥D34 WASHER RPG1419 [PACKING CASE
S1SD22-7 | TRAVERSE BASE RPG1400 [PACKING CASE
SJGDRF3107-2 |SPINDLE MOTOR RPQO333. PAD
SNSD31 i, RPQO332 PAD
SRQAO10NO4 [TURNTABLE SPRING RPNOBS8 =| CUSHION
SUWD112-2 |SHAFT PUSH PLATE RPNOBS7 ‘(CUSHION
SUXD123-1 GUIDE SHAFT SPP730 PROTECTION BAG (UNIT)
SoaD70A [OPTICAL PICKUP X2B22X20003 [PROTECTION BAG (CORD)
[soias STOPPER RUBBER ‘RPHO100 PROTECTION SHEET
RFKNLPC363P [YOKE (A) ASS’ ¥ RPHO1O1 KRAFT PAPER
[sonas-t _ {COIL Ass’ Y RPHOO8E [PROTECTION SHEET
SovD22-1 | YOKE (B)
1
XTB3+106 SCREW
XTN2+56 SCREW
RXQ0157 SUB BASE ASS’ Y
SHGD153-1 FLOATING RUBBER
RHD30031 SCREW
{sus0i36-1 |FLOATING SPRING (BLACK)
SUSD137-1 FLOATING SPRING (GOLD)
G — 53 —