To Next Page
S
swilsonJul 30, 2025
How to fix Technics CD Player tray that won’t close?
- MMary ReidJul 30, 2025
If the tray of your Technics CD Player won’t close, make sure that the disc is inserted correctly.
How to fix Technics CD Player tray that won’t close?
If the tray of your Technics CD Player won’t close, make sure that the disc is inserted correctly.
What to do if Technics CD Player display is wrong or play won't start?
If your Technics CD Player's display is showing incorrect information or the play function won't start, try the following: * Ensure the disc is inserted correctly. * Wipe the disc to remove any smudges or dirt. * Replace the disc if it's scratched, warped, or nonstandard. * If there may be condensation inside the player, wait for an hour and try again.
Why is my Technics SL-PG4 CD Player remote control not working?
If the remote control for your Technics CD Player isn't working, first check if the batteries are correctly inserted. If they are, try replacing the batteries, as they may be flat.
General| Type | CD Player |
|---|---|
| Frequency Response | 2 Hz to 20 kHz |
| Signal-to-Noise Ratio | 100 dB |
| Disc format | CD |
| Digital outputs | Coaxial |
| Channels | 2 (stereo) |
| Output Level | 2 V |
| Dimensions | 430 x 86 x 283 mm |
Statement on compliance with FCC Rules for Class B digital devices and potential radio interference.
Instructions for connecting the unit to a digital amplifier via optical cable.
Overview and page references for main unit controls.
Identifies buttons on the remote control and their corresponding page references.
Instructions for inserting batteries and warnings about mishandling them.
Guidelines for aiming the remote and factors affecting its operation.
How to start, stop, pause, skip, and search tracks during normal CD playback.
Guidelines for choosing and maintaining CDs for optimal playback.
How to select and play a specific track directly by number.
How to play all tracks or programmed tracks in a random order.
How to repeat all tracks or specific tracks.
How to repeat a specific segment between two points.
Steps to select up to 20 tracks to play in a chosen order.
How to specify tape length, adjust recording levels using peak search, and start recording.
How to select tape sides and track numbers for recording.
How to pause playback at the beginning of each track for immediate play or recording.
Temporarily reduces the output volume by 2 dB increments.
Fades out volume and pauses playback after a set time.
How to cycle through different time displays for tracks and discs.
