Technics SL-P2000 Service Manual

SL-P2000
Mi CONNECTIONS
Before connecting this unit to your audio system, be sure that the
power of this unit and all other system components are turned off.
Note:
The configuration of the AC outlet and AC power supply cord differs
CLASS 1
LASER PRODUCT
according to area.
DIGITAL
BALANCED OUT OPTICAL OUT LUOKAN 1 LASERLAITE
| KLASS 1 LASER APPARAT
(Tuoteen takaosassa)
(Apparatens baksida)
Rear panel of
this unit
A p a AC INN VOLT ADJ
[0,0 | '—* Voltage selector
(For (GC) area.)
(red) (white)
(white)
(L) igh
usehold AC
(R) outlet
(red)
1
(For
(GC)
area.)
BALANCED
OUT
Voltage
selector
(VOLT
ADJ)
Connect
to
an
amplifier
that
has
a
cannon
type
in
put
terminal
Set
the
voltage
selector
to
the
voltage
setting
for
the
area
in
which
(balanced
output).
the
unit
will
be
used.
[Use
a
minus
(—)
screwdriver.]
Note
that
this
unit
will
be
seriously
damaged
if
this
setting
is
not
Cannon
terminal
made
correctly.
If the
power
supply
in
your
area
is
117
V
or
120
V,
set to
the
“127
V"
@
Ground
@®
-
(Cold)
=
position.
@
+
(Hot)
1
Connect
the
stereo
connection
cable
(in-
cluded) to CD or AUX terminals of the ampli-
fier. DIGITAL OPTICAL OUT
This terminal can be used for connection with other equipment that
2 Connect the power supply cord (included) to has a digital input terminal, such as an amplifier, by using an optical
the household AC outlet or the AC OUTLET of cable (optional). A dust-protection cap is inserted in this terminal.
Remove this cap only when a connection is to be made to this
Technics component. ;
terminal.
For Europe:
Insertion of Connector
Even when the connector is perfectly
inserted, depending on the type of inlet
used, the front part of the connector
may jut out as shown in the drawing.
However there is no problem using the
unit.
For areas except Europe
If the power plug will not fit your socket, use the power plug
adaptor (included).
al =
Approx. 6 mms
Appliance inlet

Technics SL-P2000 Specifications

General

Brand	Technics
Model	SL-P2000
Category	CD Player
Language	English