Technics SL-P2000

SL-P2000
W CONCERNING THE REMOTE CONTROL
Battery installation
1 Open the cover.
Press gently and slide the cover out.
NO
Insert the batteries included with this unit.
When you need to replace these batteries, use two UM-4 AAA,
IEC RO3 (1.5 V) or equivalent batteries.
Use of batteries
©Be sure that you insert the batteries so that their positive (+)
and negative (—) polarities match the polarities indicated in
the compartment. Batteries instailed with incorrect polarities
may leak and damage.
Refer to “Use of batteries” for additional information.
3 Close the cover.
®Do not mix old and new batteries or batteries of different types
(carbon and alkaline, etc.).
The average battery life is about one year. Although the battery
life varies depending on how often the device is used, you should
generally replace the batteries about once a year.
Replace the batteries if commands from the remote control trans-
mitter do not operate the unit even when the transmitter is held
close to the front panel.
Never subject batteries to excessive heat or flame; do not attempt
to disassemble them; and be sure they are not short-circuited.
elf you will not be using the remote control for a long period of time,
remove the batteries and store them in a cool, dark place.
elf a battery leaks, remove all batteries and dispose of them prop-
erly. Thoroughly clean the battery compartment before inserting
new batteries. If the leaking electrolyte comes into contact with
skin or clothes, flush with water immediately.
Keep batteries out of reach of children.
Do not use rechargeable type (nickel-cadmium) batteries.
Do not attempt to recharge alkaline or carbon batteries.
eAlways remove old, weak, or worn-out batteries promptly and
dispose of them properly.
Do not dispose of used batteries in household rubbish,
Operation notes
Aim the remote control transmission window toward the unit's sen-
sor. Avoid any obstacles.
7 meters
Use the remote control within a 60-degree angle of the unit.
The reachable distance is within 7 meters directly facing toward the
unit.
Avoid dust.
Be sure the transmission window and the unit’s senor are free
from dust. Excessive dust might prevent reception.
eif direct sunlight or other strong light sources strike we remote
control signal sensor of the unit, operation may be irapaired. If
there is a problem, place the unit away from the light »urce.
ef this unit is installed in a rack with glass doors, the gaess doors’
thickness or color might make it necessary to use he remote
control transmitter a shorter distance from the unit.