Technics SL-P250 - Page 6

li DISASSEMBLY INSTRUCTIONS
Neer,
enh
CAUTION:
®
It
is
very
dangerous
to
look
at
or
touch
laser
radiation.
(Laser
radiation
is
invisible.)
e
With
the
unit
turned
“on”,
laser
radiation
is
emitted
from
the
pickup
lens.
@
When
removing
the
cabinet
and
disc
clamper
of
this
unit,
be
sure
to
turn
the
power
supply
off.
SL-P250 SL-P250
sae
Ref. No.
S-
How to remove the cabinet
:
Ref. No.
3
How
to
remove
the
disc
holder
and
power
switch
rod
Procedure | 4. Remove the 4 screws.
—=s x 7S ES CE SC 2
How to remove the disc clamper
and magnet
Procedure
1-2
e Release the claw.
¢Turn the holder in the direction of the
arrow, then release the claw.
Disc clamper
| Procedure
1-2-3
Screwdriver
.
Push
the
rack
gear
slowly
in
the
.
Pull
the
disc
holder
until
it
stops.
. Release the claw.
.
Pull
out
the
disc
holder
further
to
remove
it.
.
To
remove
the
power
switch
rod;
direction
of
the
arrow
until
the
disc
tray
comes
up.
A.
Set
the
power
switch
in
the
“OFF”
position.
B.
Remove
the
power
switch
rod
by
using a screwdriver.
Disc holder
IF
How to check the servo P.C.B.
Procedure
1-2 a —4
Traverse unit
saa How to remove the front panel
Procedure
1-6
¢When checking the soldered surfaces
of the servo P.C.B. and replacing the
parts, do as shown.
Servo P.C.B.
¢ Remove the 2 screws.
¢Slightly pull out the tab and remove
the front panel in the direction of the
arrow.
a.
Front panel
(To play a disc)
Place the test disc and magnet.
2. Turn “ON” the power switch of the
player while holding the levers of the
switches (S101, $102) in the direction
of the arrow.
Front panel
How to remove the operation P.C.B.
and headphones amp. P.C.B.
A. Operation P.C.B.
1. Remove the 4 screws (9~®).
2. Release the 7 claws.
Procedure
1-6-7
B. Headphones amp. P.C.B.
1. Pull out the level control knob.
2. Remove the 2 screws (@,@).
Operation
P.C.B. Claws
Claws
Headphones P.(.B.
8
‘psy 20
Level
control
®
knob
——_—___———_,
Pad EN ae