Technics SL-PD1010 - Page 7

Method for use
Battery installation
Insert the batteries included with this unit as shown below.
When you need to replace these batteries
Use two UM-4 "AAA", IEC R03 (1.5 V) or equivalent batteries.
Battery notes
Do not mix old and new batteries, or batteries of different types
(carbon and alkaline, etc.).
Always remove old. weak or worn-out batteries promptly and
dispose of them properly.
The average battery life is about one year.
Although the battery life varies depending on how often the
device is used, you should generally replace the batteries about
once a year.
The batteries should be replaced if commands from the remote
control transmitter do not operate the unit even when the
transmitter is held close to the front panel.
Never subject batteries to excessive heat or flame; do not at¬
tempt to disassemble them; and be sure they are not short-cir¬
cuited.
If you will not use the remote control for a long period of time,
remove the batteries and store them in a cool, dark place.
If a battery leaks, remove ail batteries and dispose of them pro¬
perly. Thoroughly clean the battery compartment before inser¬
ting new batteries.
If the leaking electrolyte comes into contact with skin or clothes,
flush with water immediately.
Keep batteries out of reach of children.
Do not use rechargeable (nickel-cadmium) type batteries.
Do not attempt to recharge alkaline or carbon batteries.
Do not dispose of used batteries in household rubbish.
Use the remote control within 60 degrees and within 7 meters (23
ft.) facing directly toward the changer's remote control signal sen¬
sor.
Remote control signal sensor
Be sure the transmission window and the unit’s sensor are free
from dust. Excessive dust might affect performance.
The operation may not be correct if direct sunlight or another
strong light source strikes the receiving sensor of this unit. If
there is a problem, place the unit away from the light source.