Technics SL-PD1010 - Page 8

Sequential play
Al! of the discs will be played, beginning from track 1 on the
selected disc.
The explanation below is an example of operation in the case
where all five disc trays in the changer are holding CDs.
POWER
Press POWER.
The unit will switch on.
OPEN/CLOSE
Press OPEN/CLOSE to open
the loading drawer.
Indicates that the loading drawer is
open.
^ S / 7 / 1 „ 0 / j . -'00
Numbers of the trays in which discs
are loaded.
27
oPEmosE Press OPEN/CLOSE again
to close the loading drawer.
imffiI
Do not attempt to close the drawer by
hand.
Current play position (The numeral illumi-
53
nates with a red color.)
'-inn nrjiOO
11 11 I U L
asc '—MS** K
Illuminates when a disc is in the disc tray. If
there is no disc in the disc tray, the indication
disappears when the disc tray comes to the
play position.
Load the dlsc(s) on the disc tray(s).
The discs can be loaded two at a time by pressing
DISC SKIP to rotate the carousel.
Do not load 8 cm and 12 cm discs on the same disc
tray.
CAUTION
Do not touch the loading drawer and carousel while they are
in motion, and do not attempt to rotate the carousel by hand;
doing so could result in incorrect operation of the unit and/or
damage to the discs.
Press the desired disc but¬
ton (1 - 5).
Mci bwj dbcj Mcs piay will begin from the selected disc.
O O U U O II a disc is not on the selected disc
tray, the changer plays the disc at the
next number.
Disc numbeMn^play Elapsed play time
(£$>*/ \\ /
V i CISC
1 0-0 1
TfltCX MIN SEC
t
1
Track number in play Play indicator
The illumination of a disc button indicates that there
is a disc in the corresponding tray. During play, the il¬
lumination color will change to green.
The changer plays all the tracks on all the discs in order and
stops automatically when the last track on the last disc finishes
playing. The first disc will then be at the playing position.