Technics SL-PG340 - Edit Mode Management

To cancel the edit mode
O
How to prepare the cassette deck for recording
If the cassette deck has no SYNCHRO EDIT terminal
To enter desired recording time other than 46, 60 or 90 minutes
TAPE LENGTH
19
Press TAPE LENGTH to select “ C----- ” then keep
pressing SKIP (|« ►►!) to enter the tape's total
playing time in minutes.
To record on side B, first press the stop button on the cassette deck,
then start recording again on side B while at the same time pressing
► PLAY on the CD player.
For example:
When the total recording time of the tape to be used is 52 minutes,
keeppressing »l SKIP until the display shows “ C- St?".
Press the play button of the cassette deck at the
same time as pressing ► PLAY on the CD player to
start recording.
When the deck has reverse mode, set to one-way ( ).
When the recording for side A is finished, the CD player will go to the
pause mode. The cassette deck will keep recording.
Press ■ STOP after recording has finished.
STOP
1. Insert the cassette tape into the cassette holder of the deck for the
synchro-edit-recording. (Be sure the tape is rewound.)
2. Select the noise-reduction system and the reverse mode
( CZO ).
3. Check to be sure that the forward-side indicator (►) of the deck to
be used is illuminated.
4. Set the cassette deck to the recording standby mode.
(Refer to operating instructions for the cassette deck to be used.)