Technics SL-PG340 - Modifying Programmed Tracks; Recording Without Synchro Edit

To cancel the edit mode
To change the programmed contents
PROGRAM
If the cassette deck has no SYNCHRO EDIT terminal
21
To record on side B, first press the stop button on the cassette deck,
then start recording again on side B while at the same time pressing
► PLAY on the CD player.
Press SIDE A/B to indicate the desired tape side.
SIOEA/B
To clear and re-enter the last track on side A or B,
press CLEAR and press SKIP (|« ►») and
PROGRAM for the new track.
CLEAR
Press the play button of the cassette deck at the
same time as pressing ► PLAY on the CD player to
start recording.
When the deck has reverse mode, set to one-way ( )■
When the recording for side A is finished, the CD player will go to the
pause mode. The cassette deck will keep recording.
To enter additional tracks at the end of side A or B,
press SKIP (K<, ►►!) and PROGRAM.
(See page 12.)
To clear the last track on the tape side A or B, press
CLEAR.
CLEAR
Press ■ STOP after recording has finished.
STOP^ j
To clear a track in the middle of the sequence,
press RECALL to display the track number to be
cleared and then press CLEAR.
RECALL CLEAR