Technics SL-PJ33 - Page 12

SL-PJ33
@ Push the arrow-marked
@ Pull out the flexible board.
part of connector.
Caution: Insert the short pin into the
flexible board in order to
prevent breakdown of laser diode.
Refer to the optical pickup handling
precautions (see page 7).
ae
How
to
remove
the
optical
pickup
Procedure
om)
10m)
11
e
Remove
the
6
setscrews.
Caution: Insert the short pin
into the flexible board.
Refer to the optical pickup handling precautions
(see page 7).
e Remove in the 4] Remove the 4
numerical order
_7™ Setscrews.
shown. oh s aX
Zo Oe
tC FT
Pull out.
| How to remove the drive coil
Solder the marked side
1. Remove the 2 yokes.
) of coil to@ and the
2. Pull out the drive coil. unmarked side to ®. Unsolder.
© Drive coil fitting
Caution:
Take care not to touch
the brush terminal here.
Pull out.
*
DC
resistance
drive
coil
36Q+1.50.
Marked
@®
—14—