Technics SL-PJ33 - Page 11

SL-PJ3
How to separate the traverse unit and
disc holder
1. Turn over the traverse unit ass’y.
2. Pull out the 3 connectors (CN101 ~ CN103).
3. Remove the 3 setscrews (@ ~ @). 3)
Note that the front and rear springs are different colors. “) Spring (yellow)
1)
|
How
to
remove
the
spindle
motor
drive
P.C.B.
©. Remove the 2 setscrews
(0. ©).
Spring (black)
Caution: Do not turn
the screw.
ae
How
to
remove
the
optical
servo
P.C.B.
Procedure
9=>10
Refer to the optical pickup handing Cautons:
precautions (see page 7). © When repairing with the optical servo
P.C.B. opened, take special care not to
e
Turn
over
the
traverse
unit
ass’y
and
remove
cut
off
the
flexible
board
of
the
optical
in the numerical order shown. pickup.
@ When the flexible board is removed,
insert the short pin into the board.
@ Remove the setscrew.
3) Release the
claw.
Slowly lift it up with care
not to damage
the flexible board.
Flexible board -\—>
ea
2] Pull out the 4 connectors
(CN101 ~ CN104).