Technics SM-ZS30 - Page 3

ENGLISH
Cautions for safest use
Installation location
1 A well-ventilated place
Take care not to use this unit m a place where it
will not receive sufficiënt ventilation, and not to
permit the ventilation holes to be covered by cur-
tains, or any similar matenals
2 Place away from direct sunlight and excessive heat
from heatmg equipment
3 A place where humidity, vibration and dust are
mimmized
Power source
1 Be sure the line voltage selector is in accordance
with local voltage in your area before connectmg
the plug to the Socket
2 DC power cannot be used
Handling the power cord
1 Never touch the power cord, or its plug, with wet
hands
2 Don ’ t pull the power cord
Metal items inside the unit may
resuit in electric shock or damage.
Do not permit metal articles to get inside the unit
Be especially careful with regard to this pomt if
children are near this unit They should be warned
never to try to put anythmg inside
If, nevertheless, some such article does get inside,
disconnect the power cord plug from the electncal
outlet, and contact the store where the unit was pur-
chased
If water gets into the unit
Disconnect the power cord plug from the electncal
outlet, and contact the store where it was purchased
As a precaution, it is suggested that fiower vases and
other containers which hold hquids not be placed on
the top of this unit
of this unit
If operation seems abnormal
Immediately turn off the power, disconnect the power
cord plug from the electncal outlet, and contact the
store where it was purchased
Discontinue usmg the unit at once Failure to do so
may resuit m additional damage or some other unex-
pected damage or accident
• Because the power source is located inside the
unit, it is normal for the cabmet to become warm
A word about the power cord
If the power cord is scarred, is partially cut or broken,
or has a bad contact, it may cause a fire or senous
electncal shock if used NEVER use a damaged power
cord for any appliance Moreover, the power cord
should never be forcibly bent
Don't touch the inside parts of this
Some places inside this unit have high voltage poten-
tial Never try to remove the top or back panels of this
unit, or to touch inside parts by hand or with tools
Contact someone who is qualified in order to mspect
the inside, or to replace a fuse, if such becomes
necessary Never attempt to do these thmgs yourself
Maintenance
The followmg suggestions will assist you in keepmg
the unit m top condition
• Be sure to switch the instrument off after use, and
do not switch the unit on and off m quick succes-
sion, as this places an undue load on the electronic
components
• To keep the luster of the surf ace and buttons,
simply use a clean, damp cloth, polish with a soft.
dry cloth Polish may be used but do not use thin 
ners or petro-chemical-based polishes
• A wax-based polish may be used on the cabmet,
although you will fmd that rubbmg with a soft cloth
will suffice
Turn the unit off when not in use When you use AC
power, appreciable current remams present even
with the Play Switch turned off If unit will not be
use for a long time, unplug the power cord
SERVICE MIST BE CARRIEi OUT BY DEALER
OR OTHER QUALIFIED PERSOi
2