Technics ST-G3 Service Manual

e Manual memory presetting
Stations can be freely preset to any desired channel.
@ Press the “FM” or “AM” button.
Before presetting broadcasting
stations, press the band selectors to
the appropriate position for your
locality.
sD Power: “on” ( B->-= )
Tech mics — Guanre symnteszer FM/AM Stereo Tuner ST-G3
power
Press momentarily, and then release.
(The memory indicator will illuminate for
approximately 5 seconds.)
beg
z
Note:
If the button is pressed continuously, the
frequency will begin to change, and the
memory will be preset automatically.
In order to stop the automatic selection,
press either the “up” button or the “down”
button.
Memory indicator
ly While the memory indicator is illuminated, press the
ST-G
<9 Press the appropriate tuning button to tune to the
desired broadcast.
¢ Auto tuning
Press the button. When the frequency
indication begins to change, release the SS)
button (a broadcasting station will be
selected automatically). Repeat this
operation until the desired station is found. Sf
¢ Manual tuning
Press the button momentarily (the
frequency will change each time the «(
button is pressed) and tune to the desired
station.
button of the desired channel.
© To preset channels 1 through 8:
8 Press the button momentarily, and then
cM release. (Preset channel number is
displayed on the channel display.)
© To preset channels 9 through 16:
bes Press the button slightly longer, and
then release. (Preset channel number
is displayed on the channel display.)
When the button is pressed, the memory indicator
illumination will stop, and the presetting is complete.
Note:
1. If the memory indication illumination stops before you
press the button, once again repeat step (4) and then
step (5).
2. If a new broadcasting station is preset into a channel,
the broadcasting station which was previously entered
in that channel will be automatically erased.

Technics ST-G3 Specifications

General

Brand	Technics
Model	ST-G3
Category	Tuner
Language	English