Technics ST-GT350 - Specifications; FM Tuner Section Specifications; AM Tuner Section Specifications; General Specifications

Thank you for purchasing this Technics product
For optimum performance and safety, please read
these instructions carefully.
Contents
Technical specifications. 2
Suggestions for safety. 3
Front panel controls. 4
Accessories. 4
Connections. ‘' g
Receiving radio broadcasts. 8
To lock a broadcast station being received. 9
If noise is excessive in the FM stereo mode 9
To check the FM signal strength. g
Preset tuning.. ’ ’' 1Q
Automatic memory presetting. 10
Manual memory presetting." . ^ 1
To listen to preset broadcast stations.’ ’ ’ ‘ 11
Troubleshooting guide. Back cover
pFor areas except Australia and N.Z.--
CAUTION:
The AC voltage Is different according to the
area.
Be sure to set the proper voltage in your area
before use.
(For details, please refer to the page 7.)
-For Australia and N.Z.-___
THIS TUNER/RECEIVER IS CAPABLE OF RECEIVING THE
Zo A stat1o E n E s° BR0ADCASTS FR0M THE am band
HOWEVER LIKE MANY TUNERS AND RECEIVERS CURRENT¬
LY AVAILABLE ON THE MARKET IT WILL REPRODUCE THIS
AM STEREO SIGNAL ONLY IN AM MONO, WHICH, IN EF¬
FECT, IS OF NO LESSER QUALITY THAN YOUR EXISTING
AM MONO TUNER/RECEIVER.
70 dB (75 dB, IHF)
65 dB (70 dB, IHF)
9 FM TUNER SECTION
ESS 87 ' 5 °' , 0 8 0 °
S/N 30 dB 1-5 pV (IHF, usable)
S/N 26 dB 13 UV (75 0)
S/N 20 dB 1^(75 0)
IHF 46 dB stereo quieting sensitivity 28 Jv (75 S
Total harmonic distortion p u '
MONO
STEREO °- 2 %
S/N °- 3 %
STEREO 70 dB (75 dB, IHF)
Frequency response 20 Hz-15 kHz^+iisTo -^dB
Alternate channel selectivity °
±400 kHZ RS HR
Capture ratio dB
Image rejection at 98 MHz
IF rejection at 98 MHz IT “3
Spurious response rejection at 98 MHz 7 * hr
AM suppression „
Stereo separation as
1 kH *
Carrier leak 40 dB
3fliS -30 dB (-35 dB, IHF)
Channel balance (250 Hz-6.3 kHz) 50dB( 55 dB ’^
Limiting point * , ^
Bandwidth 1 2 pV
IFamp,l,l8r 180 kHz
FM demodulator
Antenna termlnal(s) 75 Q (unbalanceHi
-30 dB (-35 dB, IHF)
-50 dB (-55 dB, IHF)
±1.5 dB
1.2 pV
180 kHz
1000 kHz
75 Q (unbalanced)
9 AM TUNER SECTION
Frequency range 522-1611 kHz (9 kHz steps)
Sensitivity (S/N 20 dB) at 999 kHz 3 °” ^ “S/JS ^oVjv/m
Selectivity (±9 kHz) at 999 kHz M 4 « dB
Image rejection at 999 kHz An
IF rejection at 999 kHz 50 ^
9 GENERAL
Output voltage 0 3 V 1 06 V ihf\
Power consumption ( °' 6 Vl ' H F >
Power supply y w
For Australia and N.Z. AC 50/60 Hz, 230 - 240 V
For others AC 50/60 Hz. 110-127 V/220-240 V
mmenslonsOVKHxD) 430x69.3x301 mm
We ' 9h ‘ 2.6 kg
Notes:
1 Specifications are subject to change without notice.
Weight and dimensions are approximate.
2. Total harmonic distortion is measured by the digital spectrum
analyzer.