Technics SU-X911 - Page 4

m@ DISASSEMBLY INSTRUCTIONS
Lo | Removal of the Cabinet oe Removal of the Front Panel
Procedure Procedure
1 152
2)
Co
(Bottom Side)
O She iat etna ed oat tee
a
/ 1
if: | \
/ ;
a 4
0
12)
.3
1. Remove the 3 screws (@~®).
2. Remove the flat cable (J501).
3. Remove the front panel in the direction of the arrow.
Cabinet
JT TT) =
LM
_— J 50!
—
Procedure
12-53
Power Switch
y Front Panel
How to remove the flat cable
I
Pull out the flat cable while pressing y
the connector.
1. Remove the power switch knob by pushing it from behind
the front panel.
2. Remove the 2 screws (@, @).
Ref. No. Removal of the FL Drive/Tone Removal of the Volume P.C.B.
4 Amp P.C.B. and Volume P.C.B. 1. Remove the 1 knob (@).
Procedure | Removal of the FL P.C.B. . See i os (®).
152-54 | 1. Remove the 3 knobs (Q@~®). - Remove the 2 screws (@, ©).
2. Remove the 3 nuts (@~@).
3. Remove the 5 screws (@~@).
Flgtie
Connector
: 16
C: longer than 3)
18mm
Use a wrench of the
dimensions shown in
the illustration above
to remove nuts.