Technics SX-K350

(2) To store each part separately (multiplex storage)
—_
Turn off all four Play Sequencer buttons.
Press the button. The button will flash.
3.
Press
the
Play
Sequencer
button
for
the
part
to
be
stored
first. The button will flash slowly.
. Play the part to be stored.
5.
After
playing
the
part,
press
the
Play
Sequencer
button
for
the
next
part
to
be
stored.
The
button
will
flash
slowly.
® Ifdesired, youcan exit the Play Sequencer record mode at
this point by pressing either the MZ buttonorthe 7S
button for the part that was just stored.
¢
Check
at
this
time
that
the
button
for
the
previously
stored
part
is
still
lit.
e Ifyou have exited the record mode then steps 1—4 above
must be repeated to store the next part.
vn
>
6.
Pressing the button begins the automatic
performance of the previously stored part(s).
When adding parts to the previously stored parts, step 6
must be performed to commence recording.
To begin playback of a song with no rhythm, press the
button.
. Repeat steps 5 and 6 until all four parts have been
recorded.
. When recording is complete, press the MM button to
exit the record mode.
To play back any or all of the stored parts, make sure that
the button for that part or parts is lit.
When each of the four parts is recorded separately, the
entire keyboard can be used for each part.
(3) Using Auto Play Chord
It is possible to use One-Finger and Fingered modes when
recording a Play Sequencer performance.
1. Turn onone finger or fingered buttons along with memory
button if desired.
2. Press the M4 button.
3. Press the Play Sequencer left button.
. Play as described in the Auto Play Chord section.
In this case both the bass and accompaniment voices are
stored in left. This is convenient in case extra memory is
needed for the solo section. (See section on storing two
parts together in double mode.)
(4) Storing two or more parts together
Two parts may be stored simultaneously. The following
combinations are possible:
bass and right
bass and solo
left and right
left and solo
In this case the keyboard split function will turn on
automatically, so be sure to program the keyboard split
position first.
@ To store two parts
The combination of either bass or left, and right or solo may
be stored as follows:
1. Turn off all four Play Sequencer buttons.
2. Press the NEB button. The button will flash.
3. Press the two Play Sequencer buttons you wish to store
one at atime.
The buttons will slowly flash.
4. The keyboard splits into melody and accompaniment
sections. Play the two parts at the same time.
. Press the
Bass and left are played below the split, and right and solo
are played above the split.
Any other combination is possible. However, bass andleft
will be recorded in unison, as will right and solo.
When using the combination of bass and left, or right and
solo, keyboard split will not be activated.
If three or four parts are recorded simultaneously, the
keyboard split function will turn on automatically.
. When finished playing, press the next two Play Sequencer
buttons you wish to store one at a time. The buttons will
slowly flash.
button to begin playback of the
previously stored parts.
. Play the new part while the previously stored parts are
playing.
Press the MZ button when finished to exit the record
mode.
[6]