Technics SX-K350

@ To record more than two parts simultaneously
. Press the MEZ2ZM button.
2. Press the Play Sequencer button for each part you wish to
store. The buttons will slowly flash.
3. Play the song to be stored. Some parts will be in unison as
previously mentioned.
4. Press the MB button when finished to exit the record
mode.
ook
(5) Memory capacities
There are three modes available for memory capacity:
NORMAL — allows storage in all four sections.
DOUBLE — storage is possible in up to three sections with
increase in note capacity.
QUADRUPLE — storage is possible in only one section but
note capacity is greatly increased.
NORMAL — The keyboard is in this mode when it is first
turned on. Storage is possible in all parts as previously
explained.
DOUBLE — The memory capacities of left and right, and the
memory capacities of bass and solo can be combined. For
example, if recording a song in which a solo voice is not
needed, the solo section’s memory can be combined with the
bass section’s memory. In this mode, recording a solo part is
‘not possible, but the note capacity of the bass part doubles.
Likewise, the bass memory can be eliminated, which in turn
doubles the solo storage capacity. This is an effective
technique when using Auto Play Chord to record a bass part
inthe left section. (See “Using Auto Play Chord” section.) Itis
also possible to combine the memory capacities of the left
and right sections. As with bass and solo, eliminating the left
storage capacity doubles the available notes for the right
section, and eliminating the right storage capacity doubles
the available notes for the left section.
To enter double mode:
1. Press the MZM button.
2. Press the Play Sequencer button for the section you wish
to double the memory capacity.
3. Press the button to turn it on.
4. Press the white key [2].
G
ab
}—_}
A
ab ab B Cc Sp
. Press the EX¥@ button again to turn it off.
. Press EEZSIEM to exit record mode.
7. To retugnto normal mode, follow above procedure except
press key [1] in Step 4.
QUADRUPLE — The entire memory capacity of the Play
Sequencer can be combined into one section. In this mode,
only one section can be recorded. This mode allows the
longest possible piece of music to be recorded.
To enter quadruple mode:
1. Press the HE22™ button.
2. Press the Play Sequencer button for the part you wish to
store.
3. Press the button to turn it on.
4. Press the white key [4].
norer ST g@ [4]
&b G eb A tb B C Bb 0
5. Press the button again to turn it off.
6. Press MZ to exit record mode.
7. To return to normal mode, press key [1] in Step 4.
The Musical Display indicates the amount of storage
capacity remaining as a percentage, the part which is being
stored, and the mode that section is in.
€MusicalzDisplay=
@) The remaining storage capacity for the part being
stored is displayed as a percentage on the Musical
Display. When storing in two Play Sequencer buttons
simultaneously, the lower of the two percentages is
displayed. When 0% appears and the error alarm beeps,
storage is not possible.
@ ~~ &...right 5 ...solo presets
L...left B...bass
@ / ...normal mode 2 ...double mode
4 ...quadruple mode {...This part cannot be
stored.