Technics SX-K350

e The storage capacity is as shown below:
right | bass | solo control
Storage in 4 parts 140 100 100
(normal mode)
Storage in only 2
parts (double *200 **10
mode)
Storage in only 1
part (quadruple
mode)
*The number of tones that can be stored doubles or
quadruples when only two or one part is used as shown
above.
**During storage using the right button, control data such as
changes in the tones and effects being played can also be
stored.
(6) Registration storage
@ Registration storage
When Play Sequencer storage operation is performed, the
contents set before the [= button is pressed are
automatically stored.
@ Checking registration before performance
Turn on the button and then press on the
keyboard. The control panel will indicate the beginning
registration of the stored performance.
@ Modifying the beginning registration
The beginning registration of a performance can be
modified while in the Play Sequencer record mode
( @Zarli and ?S buttons flashing slowly).
1. Turn on the button.
2. Change voices, rhythm, and effects as desired.
3. Turn off the button.
@ How to Count the Number of Tones
The cycle of one key being pressed and released is
counted as one tone.
© The rhythm tempo can be freely adjusted during playback
Therefore, it is possible to store contents by playing the
keyboard slowly.
© If new songs are stored over songs already stored, the
previously stored songs are cleared.
H Modifying a stored registration
The beginning registration of a performance stored in
Play Sequencer memory can be modified as follows:
1. Set the registration you wish to store.
2. Press the HZ button. The button will flash.
3. Press the button. The button will flash slowly.
4. Press on the keyboard.
@ Storage of changes in registration during performance
The right button of the Play Sequencer stores changes in
registration in the buttons on the control panel, excluding
the slide controls, Play Sequencer, and buttons.
This information is stored along with the information for
the right part.
(7) To modify previously stored parts or add a solo part
1. Turn on the Play Sequencer button for the part to be
automatically played.
2. Press the HEQ2Z—i button. The button will flash slowly.
3. Press the Play Sequencer button for the part to be
replaced. The button will flash slowly.
e Check at this time that the button for the part to be
automatically played is still lit.
4. Pressing the button begins automatic perfor-
mance of the stored part to which a new part is being
added.
e You can also begin a song which has no rhythm by
pressing the button.
5. After playing, press the button to turn it off.
For Automatic Performance of the Stored Contents
© To use the stored tones and effects, turn on the
button and then press the key on the keyboard.
1. Press the Play Sequencer button to turn on the part you
wish to perform automatically.
@ Make sure that only the Play Sequencer button for the part
you wish to perform automatically is lit. (If the Play
Sequencer button for any other part is turned on, the
wrong melody may be played or the rhythm may stop
during performance.)
¢ If the solo presets button of the Orchestral Conductor is
turned on during automatic performance of the melody
stored in the solo part of the Play Sequencer button,
manually played voices will also be produced. This may
adversely affect the solo presets.
2. Start the rhythm for automatic performance of the
selected part.
e Press the button to begin a song which has no
rhythm.