Technics SX-KN6500

11.2. Removing the HB, MB, CPL, ROT, CPC, CPR, CNB, ACP, FAJ,
JACK, ASUB printed circuit boards
- Follow the item 11.1..
- Pull out the connectors on the printed circuit boards.
HB P.C.B.
- Remove the HB P.C.B. mounting screws ( 2 pcs.) as shown in
Fig.4 .
MB P.C.B.
- Remove the MB P.C.B. mounting screws ( 3 pcs.) as shown in
Fig.4 .
CPL P.C.B.
1. Pull off the MAIN VOLUME knob and APC/SEQUENCER VOLUME
knob as shown in Fig.4 .
2. Remove the CPL P.C.B. mounting screws ( 9 pcs.) as shown in
Fig.4 .
ROT P.C.B. and CPC P.C.B.
1. Pull off the TEMPO/PROGRAM dial as shown in Fig.4 .
2. Remove the ROT P.C.B. mounting screws ( 2 pcs.) as shown in
Fig.4 .
3. Remove the CPC P.C.B. mounting screws ( 7 pcs.) as shown in
Fig.4 .
CPR P.C.B.
- Remove the CPR. P.C.B. mounting screws ( 9 pcs.) as shown in
Fig.4 .
CNB P.C.B.
- Remove the CNB P.C.B. mounting screws ( 3 pcs.) as shown in
10