Technics SX-PR100 Service Manual

[4] How to remove the keys
Remove the keyboard according to procedure 3.
© Lift up the claw as shown Fig. 11-©
@ The key push to forward as shown Fig. 11-@.
Key can be removed from chassis.
® Lift up the key and take it out from chassis.
Note:
«In the case of disassembly black key remove the
right and left white key at first and after that
black key can be removed.
Reassembly method
©® Insert the spring in to the hammer notch with
the tang pointings-up as shown in Fig. 11-©. :
@ While holding the. spring against the hammer, [Fig. 11]
place the rear edge of the spring in the notch in-
side the rear edge of the key.
® Slowly push the key down into the slots in the
chassis. .
[5] How to remove the printed circuit boards
FD Connector P.C.B. (Fig. 12)
Remove the 3 screws © on the connector unit.
Main P.C.B.
¢Remove the 6 screws @ on the Main P.C.B.
(Fig. 13)
¢Remove the 3 screws @ on the back of the top
cover. (Fig. 14)
*In the case of remove the P.C.B. except the
above-mentioned, release the clows of P.C.B.
holder and remove the screws on the each
P.C.B.
[Fig. 12]
P.C.B. asm P.C.B.
CPL
OOOO OO ©©
6 [al
[Fig. 14]
[Fig. 13]

Technics SX-PR100 Specifications

General

Brand	Technics
Model	SX-PR100
Category	Musical Instrument
Language	English