Technics SX-PR100 User Manual

oh
. Press the RECORD button. The indicator will flash.
2. Press the PCC button. The indicator will flash slowly.
3. Press and hold the C-chord, either as a one-finger or
fingered mode. While holding the C-chord key(s), press
the key marked KY.
¢ The chord sounds while you're holding it; as you press the
K—1_ key, you'll hear a “beep”—this tells you the chord
is now in the memory. ALWAYS REMEMBER: When you
hear the chord you want, THEN press [4+ or
Ko.
Cc
re)
¥ :
4. While holding down F-chord, press the KA key.
5. While holding down G-chord, press the KAY key.
6. While holding down C-chord, press the K—*7 key.
7. Press the —H (end) key. This closes the memory to
further storage, and turns off the RECORD button. The
indicator for the PCC button stays on, however.
Other facts you should know about storing chords...
© To store “no chord” (N.C.) pressthe (e+4 or fA
key, as necessary, without playing a chord.
e ifthe — key is pressed twice while playing a chord,
that chord will be stored for two measures.
® When using the one-finger mode to store minor or seventh
chords, press a black or white key to the left of the
depressed major chord key.
@ When the programmed chord sequence is automatically
played back, it stops after one play. For repeat automatic
play, follow the procedures below in step 7 above.
@ To repeat the programmed chord sequence until the
rhythm is stopped:
Instead of the —H_ key, press the G> keys (pressing
the D.S. and —+{ keys at the same time).
® To specify the number of repetitions (up to 8 times):
While holding the D.S. key down, press one of the keys
2 to 8 corresponding to the number of repetitions (e.g.
the 3 key to repeat 3 times). Then press the —/# key.
@ Ifyou press the + & key when storing the chord sequence,
the sequence will stop at the first beat of the next chord
during automatic playback. Pressing the START/STOP
button resumes the sequence at the chord next to the
stopped one.
e For example, press the G7 Kj ,4 &, C KI and
Am -— keys for storage. When automatically played
back, the chord sequence stops at the first beat of the C
chord after the G7. Pressing the START/STOP button
resumes the sequence at the Am chord.
Playing the programmed chords
® Set to AUTO PLAY CHORD (either BASIC or ADVANCED).
After making sure the PCC indicator is on, start the rhythm of
your choice. The stored chords are automatically repeated in
sequence for the correct number of measures.
When you are playing a programmed chord sequence and
you wish to replay a certain part of the program—-maybDe you
missed a melody note—press the START/STOP button. This
stops the rhythm and the chords; at the same time, the
program returns to the beginning of the chord sequence,
allowing you to restart and play again.
Modifying or correcting programmed chords
Suppose you wanted to change the F chord in the example to
a Dm—here are a couple of ways you could do it.
Using the automatic rhythm
1. Press the RECORD and PCC buttons.
2. Press START/STOP to begin the chord sequence with the
rhythm.
3. Stop the rhythm when the sequence reaches the F chord.
4. Play and hold the D key and a black key to the left of it, and
press the f—— key. The new chord is now in the
position of the original chord.
5. Press PCC again.

Technics SX-PR100 Specifications

General

Brand	Technics
Model	SX-PR100
Category	Musical Instrument
Language	English