Technics SX-PR100 User Manual

Using the forward ( > ) or back ( <« ) Keys
1. Press the RECORD and PCC buttons.
2. Press the B key once for each chord from the start of the
program. In this case, the F is the second chord in the
sequence; watch the example and press B> twice.
3. Stop when you hear the chord you want to change.
Steps 4 and 5 as above.
The ~@l keyis used the same way when you want to move one
’ chord at a time from the end of the program to the beginning.
Other facts you should know about changing chords...
e The B and ~@ keys operate only when the rhythm is
stopped and the RECORD and PCC buttons are pressed.
© Each press of the > key advances the sequence one unit
and each press of the ~@ key moves the sequence back
one unit, whether the unit is a whole measure, a half-
measure, or a quarter-measure.
@ Should you enter the wrong chord, press the ~#f key once
and enter the correct chord.
Using the -§ 6, p.s. Keys
After pressing the symbol keys according to the music sheet,
the chord of the measure is stored. Let’s try to store the
following music.
SS
Cc
The memory procedure is as follows.
@ @ ©) © 6)
SS Se ee +
® ®
fom
a
fom
G7-
a
+[c-
S
{|
Music written with repeat marks other than %, @ and
D.S. can be stored with the following correspondence.
ain
== ’ = , Fine
an
D.S.. D.C., al Fine , =
(For ¥ , press the § @, D.S. keys in succession.)
11
Example
oF =0 ee = — =}
The memory procedure is as follows:
[s¢}-[@ }48¢}-@]-[25]-(O}{O)-L)
The following kinds of music cannot be stored by using © #,
D.S. keys. hh
e When the position of = and “to @” are the same.
e When the ranges of two repeats overlap.
@ When the position of SE and D.C. or D.S. are the same.
IM—--OzZzm

Technics SX-PR100 Specifications

General

Brand	Technics
Model	SX-PR100
Category	Musical Instrument
Language	English