EasyManua.ls Logo

Technics SX-PR350

Technics SX-PR350
51 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PartV
Externalmemory
Errordisplay
If an error message appears on the display, follow the appropriate steps to solve the problem.
Warning:
. Some pre-recorded disks (for example, those recorded by the manufacturer) are copy-protected. Data
from these disks cannot be copied.
. When the power is turned off after a copy-protected song has been loaded, the SEQUENCER contents
will be erased.
. If a copy-protected song has been loaded and you want to then record a new song in the SEQUENCER
and save it on a disk, be sure to first turn the power off once or perform the initialization procedure.
35
Display
Remedy
,-"
The memory disk has not been formatted by the Digital Disk Recorder.
,- J- Lt
. Insert a correctlyformatted disk.
, -
Loadingfailure.
I
. Perform the loading procedure again.
L'
I
No memorydisk in the Digital Disk Recorder.
i-"
. Inserta memorydisk.
CJ-L
,- -
You have attemptedto load a song numberwhich has not been saved.
. Load a song numberwhich has beensaved.
L' _I"
No Digital Disk Recorder.
,
- LI
. Install the SY-FD20 (PR50V/PR250).
L J I
,- J-
Saving failure.
C J- _I
. Performthe savingprocedureagain.
The memorydisk is write-protected.
,-,-
. Close the write-protectwindow of the disk.
, ,- J t
No remainingmemorystorage capacity.
,- I
. Insert a new disk, perform the saving procedure after formatting it.
,-,- t
Formatting failure.
,-"
. Performthe formattingprocedureagain.
, ,-, t
,-"
You have attempted to save a song which is copy-protected.
,-,- I
. A copy-protectedsong cannot be saved.
The SEQUENCERdoes not function becausethe EXT SEQ MODE is on.
,-
II
. Setthe EXTSEQMODEto off. (Referto page47.)
C
I _I

Other manuals for Technics SX-PR350

Related product manuals