Technics SX-PX228B

The following MIDI functions can be set.
The BRILLIANCE buttons and some of the
SOUND buttons, when used in conjunction with
the MODE SET button, serve to set the following
MIDI functions.
| Function | on (when indicator is lit) off (when indicator is not lit)
The piano can be used as a multiple | This piano cannot be used as a multiple
sound generator, and data can бе ! sound generator. Data can be received
received on each MIDI channel (1 to 13). | only on the set MIDI basic channel
In this case, the channels set the to | (LEFT, RIGHT). In this case, the
RIGHT and LEFT parts are disabled. produced sound corresponds to the
selected sound as indicated on the panel
(the LEFT SOUND corresponds to the
selected sound on the panel only when
the keyboard is spiit) (default status).
MULTI
TIMBRE
oln the initialized state, the МО! channel and sound assignment that can be used
on this instrument is as shown below (the ORGAN PRESETS becomes the sound
that is selected at that time).
LEFT SOUND SOUND
EET “Ter BG Hue owo umor ох cnoi cower ue vaes sos vocu RS
чено 059059090900
e When the power is turned on or when this instrument is initialized, the sounds
for each channel that were changed by receiving PROGRAM CHANGE numbers
return to the sounds indicated on the panel.
Data is received for al! MIDI channels. | Data is received only on MID! channels
which are matched (default status).
eFor assigning this instrument's MIDI
channels, refer to page 19.
PROGRAM CHANGE data is not
transmitted/received.
PROGRAM CHANGE data is
transmitted/received (default status).
o You can also transmit data for any
PROGRAM CHANGE number.
(Refer to page 22.)
о Please refer to page 22 for information
about the program change number of
each sound button.
PEDAL Pedal operation data is transmitted/ | Pedal operation data is not transmitted/
received (default status). received.
EFFECT The DIGITAL EFFECT on/off status is | The DIGITAL EFFECT on/off status is
transmitted/received (default status). not transmitted/received.
When this instruments TRANSPOSE | When this instruments TRANSPOSE
TRANSPOSE
PROGRAM
CHANGE
function is active, note numbers of the | function is active, note numbers of the
transposed notes are transmitted. played keys (non-transposed notes) are
transmitted (default status).
The performance from this instrument
also sounds from this instrument (default
status).
eWhen the POWER is turned on, the
LOCAL CONTROL is set to on.
The performance from this instrument
does not sound from this instrument. Set
to off when this instrument is to be used
only to transmit data to connected
equipment.
LOCAL
CONTROL
(LEFT/RIGHT)
e MULTI TIMBRE and OMNI ON cannot both be turned on at the same time.
20