Technics SX-PX552

More about SEQUENCER recording
Expressed in terms of notes, the total number
of notes which can be recorded in both SE-
QUENCER tracks is about 4500. (The num-
ber of notes may be reduced if operations
such as depressing the pedal are carried
out.)
When the remaining SEQUENCER storage
capacity becomes 20% or less, it is indicated
on the display as %.
When an error tone sounds and “FuL” ap-
pears on the display, the memory is full and
the recording mode stops automatically.
If you perform the procedure to record on a
track that is already recorded, the previous
contents of the track will be erased.
Playback
1. Confirm that the indicators are lit for the tracks
you wish to have played back.
SEQUENCER
STARISTOP ГВ ЕР) TRACK! TRACK 2
e Tracks whose indicators are not lit will not be
played back.
e The tempo setting will appear on the display.
Erasing a track
While pressing the MODE SET button, press the
button for the track you wish to erase until a beep
tone sounds (about 2 or 3 seconds).
MODE
SET
TRACK 1 TRACK 2
0/ ПО
e The contents of the track are erased, and “cLr
appears on the display.
e You can erase both tracks at the same time
by pressing the two track buttons simul-
taneously.
e You cannot erase a track by this method when
the RECORD button is on.
n
17
You cannot record both tracks at the same
time.
The VOLUME and BEAT settings of the
count are those which are set for the
METRONOME. (Refer to page 14.)
You can use the METRONOME while record-
ing.
For difficult tunes, for example, you can
record at a slow speed and play back at a
higher speed without changing the pitch.
. Press the START/STOP button.
È
The recorded tune is played back from the
beginning. `
If the METRONOME is on, playback begins
with a one-measure count.
You can adjust the playback speed with the
TEMPO buttons.
e |f the recording procedure was not performed
correctly, “Err” will appear on the display when
you attempt to play back the tune.
The contents of the SEQUENCER remain in
the memory for about one week after the
POWER is turned off.