Need help?Do you have a question about the Techniglass The Grinder and is the answer not in the manual?
General| Brand | Techniglass |
|---|---|
| Model | The Grinder |
| Category | Grinder |
| Language | English |
Covers essential safety practices for operating the glass grinder, including eye protection and electrical safety.
Details on water reservoir levels, preventing electrical contact, and proper installation of components like the shaft seal.
Steps 1-4 focus on connecting the power cord, removing the lift grid, and installing the Aqua Flow System.
Steps 5-8 involve adding water, positioning the lift grid, and installing the guard and LumiShield arm.
Steps 9-11 cover installing the transparent shield, bit guard, and operating the power switch.
Steps 1-4 describe removing the guard, bits, and brush for platform setup.
Steps 1-3 cover installing the shaft water seal, aligning the upper platform, and installing the Aqua Flow System.
Steps 4-6 detail adding water, installing a jewelry bit, and positioning the lift grid.
Covers powering off, draining water, cleaning brushes, reservoir, and eye shield.
To Next Page