PG 21
1. Draw out the lower and upper basket, load the dishes and push them back. It is
commended to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page”Product fiche”. Make
sure that the water supply is turned on to full pressure.
4. Close the door, press the Power button, to switch on the machine.
5. Choose a program, the response light will turn on. Then press the Start/Pause button, the
dishwasher will start its cycle.
Starting A Wash Cycle
Changing The Program Mid-cycle
A wash cycle can only be changed if it has been running for a short time otherwise, the
detergent may have already been released and the dishwasher may have already drained the
wash water. If this is the case, the dishwasher needs to be reset and the detergent dispenser
must be refilled. To reset the dishwasher, follow the instructions below:
1. Press the Start/Pause button to pause the washing.
2. Press the Program button for more than 3 seconds, the dishwasher will enter standby mode.
3. Press the Program button to select the desired program.
4. Press the Start/Pause button, the dishwasher will run after 10 seconds.
PROGRAMMING THE DISHWASHER
To Next Page
Loading...
Need help?
General
