PG 16
USING THE DISHWASHER
Filling The Rinse Aid Dispenser
1
2
Remove the rinse aid dispenser
cap by rotating it counterclockwise.
3
Close the rinse aid dispenser cap
by rotating it clockwise.
Pour the rinse aid into the dispenser,
Adjusting the rinse aid dispenser
The rinse aid reservoir has six settings. Both the
recommended setting and the factory setting is “3”.
If the dishes are not drying properly or are spotted,
adjust the dial to the next higher number until your
dishes are spotfree.
Reduce it if there are sticky whitish stains on your
dishes or a bluish film on glassware or knife blades.
NOTE:
Clean up any spilled rinse aid with an
absorbent cloth to avoid excessive foaming
during the next wash.
Rinse-Aid indicator
To Next Page
Loading...
Need help?
General
