90
6 Initial installation
Aer you have read the safety instructions and connected the device as described
in Chapter 4, you can then switch it on as described in Chapter 5.
On initial installation of the device, the AutoInstall installation wizard starts
automatically. The installation wizard allows you to make the most important
seings for your digital receiver in the simplest way possible.
Each step of the installation explains which seings can be made.
> In the installation wizard start window, you can cancel the initial installation
by pressing the red function key. The receiver then begins to run default pre-
programming.
In the subsequent installation steps you can press the OK key to accept the
seing you have selected and move on to the next installation step.
By pressing the Back key you can go back to the previous installation step.
This enables you to correct any incorrect entries at any time.
The initial installation shown here simply is an example.
The exact process for the initial installation will depend on the seings you select.
Therefore please follow all instructions displayed on screen carefully.
Digit S3 DVR_V2.indd 90Digit S3 DVR_V2.indd 90 23/02/2022 08:5323/02/2022 08:53