TechniSat DIGITRADIO 231 OD - Page 132

132
> Use TUNING/SKIP to select one of the alarm time memories Alarm 1 or Alarm 2
and press the SELECT buon to launch the configuration.
> Then go through all the points one in sequence with TUNING/SKIP. Confirm each
input by pressing the SELECT buon.
[Alarm]
Switch the alarm on and o with the SELECT > [On ] or [O] buons. The alarm
is only activated when it is set to [On] here.
[Repeat]
Press the SELECT buon. You can choose between Daily (every day of the week),
Once, Weekdays (Mon - Fri) and Weekends (Sat and Sun). Press the SELECT
buon to apply the seing.
[Alarm time]
Here you can enter the alarm time and date, if required.
Using the TUNING/SKIP buons, first select the hours and press the SELECT
buon to save. Then enter the minutes. Accept this too by pressing the SELECT
buon.
If Repeat > [Once] has been selected, you must also enter the date as well as
the time. This item is then called [Date/Time].