What to do if there is no sound in Bluetooth mode on my TechniSat Car Receiver?
If you're not getting any sound via Bluetooth mode on your TechniSat Car Receiver, first ensure that your mobile device is paired with the DIGITRADIO. If it is paired, check the volume level on your mobile device and increase it if necessary.
Why is there interference at low volume on my TechniSat Car Receiver?
If you are experiencing sound interferences at low volume music using your TechniSat Car Receiver, it might be due to the volume setting on the DIGITRADIO being too high. Try decreasing the volume output on the DIGITRADIO and increase the volume on your car radio system instead.
How to fix no sound via LINE OUT on TechniSat Car Receiver?
If your TechniSat Car Receiver displays no sound via LINE OUT, check that the 3.5 mm audio cable is correctly connected to the LINE OUT plug on the DIGITRADIO. Also, verify the volume settings on your car radio system and on DIGITRADIO. Finally, ensure sufficient DAB+ reception by changing the location and starting a new DAB scan.
What to do if there is no sound via LINE IN / AUX on TechniSat Car Receiver?
If your TechniSat Car Receiver isn't producing any sound via LINE IN / AUX, first check the volume settings on your mobile device and increase the volume if necessary. Also, ensure that the 3.5 mm audio cable is correctly connected to the green LINE IN plug on DIGITRADIO.
Why is my TechniSat Car Receiver showing no display and no function?
If your TechniSat Car Receiver's display is off and there's no function, make sure the car ignition is on to supply power to the 12 Volt car plug. Check that the device fits correctly on the cigarette holder and that the cigarette holder is plugged correctly in the 12 Volt car connector. Finally, verify the fuse of the cigarette holder is working correctly by checking the LED; it should display “Charge”.
How to improve bad audio quality via FM transmitter on TechniSat Car Receiver?
If you are experiencing bad or poor audio quality while transmitting the signal via the FM transmitter on your TechniSat Car Receiver, it might be due to interference with another FM frequency. Try selecting another frequency on both the car audio system and in the FM transmitter settings of the DIGITRADIO.
Warning about potential distraction and dangerous situations when using the radio while driving.
Caution regarding hearing damage from prolonged exposure to high volumes, especially with headphones.
Instructions for charging the device using the supplied cable and a USB port.
Information on potential interference with other electronic equipment and medical devices.
Warning that some accessories may present a choking hazard to small children.
Specifies the safe operating temperature range for the device: -20 °C to +70 °C.
Instructions for connecting the device to the car's power supply via cigarette lighter or USB.
Guidance on installing the external DAB antenna on the car's windscreen.
Methods for connecting the device to the car radio system via LINE IN or FM transmitter.
Steps to perform a DAB+ scan and select radio stations using the device.
Instructions for pairing and connecting a mobile device via Bluetooth for music playback.
How to play MP3 music from a Micro SD card inserted into the device.
Instructions for playing music from external devices via the 3.5mm audio cable.
How to access and navigate the device's settings menu.
Using the DIGITRADIO for hands-free calls via Bluetooth connection.
General| DAB Radio frequency range | Band III 174- 240 MHz |
|---|---|
| FM Transmitet r frequency range | 87.6 MHz- 107.9 MHz |
| Bluetooth Modul | ATS V 4.2, A2DP, HFP, AVRCP |
| Display | VA Display |
| Power supply | 5 Volt 500mA |
| Micro SD cardreader | Micro SD Card up to 32 GB Fileformat: MP3 |
| LINE IN/LINE Out | Stereo 3, 5 mm Klinke |
| Accu | 800 mAh |
| Temperature | -20 C0 - + 70 C0 |
Weight and Dimensions| Dimension | 49 X 76.5 X 30.79 |
|---|
To Next Page
