TechniSat DIGITRADIO Car 1 User Manual

30
E
5.2. Antenna
Install the external antenna as per the below diagram.
Make sure your antenna was not snapped while shipping
Dentify the location of antenna well before fixing,
The adhesive will be decreased a lot at next time
Dry and clean your windscreen before fixing the antenna
Make sure the length will be enough under your route
Gently unpeel the backing of the antenna and aach to your windscreen, then apply gentle pressure until
the film is held firmly position.
Connect the antenna to the gold plug contact on the right side of DIGITRADIO Car 1. (Please see chapter 4)
Please note:
Do not place the antenna in the field of view on the car.
Do only fix the antenna on places, where there is no disturbance in viewing the trac.
5
▼Cauous: Make sure the unit charging contacts connected with the docking contacts in right way! Or it
can’t power on!
2. Antenna installaon
Install the external antenna as per the below diagram,
Noce
 Make sure your antenna was not snapped while shipping
 denfy the locaon of antenna well before xing, The adhesive will be decreased a lot at next me
 Dry and clean your windscreen
5. Installation

TechniSat DIGITRADIO Car 1 Specifications

General

DAB Radio frequency range	Band III 174- 240 MHz
FM Transmitet r frequency range	87.6 MHz- 107.9 MHz
Bluetooth Modul	ATS V 4.2, A2DP, HFP, AVRCP
Display	VA Display
Power supply	5 Volt 500mA
Micro SD cardreader	Micro SD Card up to 32 GB Fileformat: MP3
LINE IN/LINE Out	Stereo 3, 5 mm Klinke
Accu	800 mAh
Temperature	-20 C0 - + 70 C0

Weight and Dimensions

Dimension	49 X 76.5 X 30.79