How to improve DAB/FM reception on TechniSat DIGITRADIO 371 CD IR Radio?
To improve poor DAB+/FM reception on your TechniSat Radio, fully extend the antenna and try changing the position of the antenna or the DIGITRADIO 370/371 CD IR.
What to do if there is no sound from AUX input on TechniSat DIGITRADIO 371 CD IR?
If you're not getting any sound from the external input (AUX) on your TechniSat Radio, check the following: * Ensure the device is connected correctly. * Verify that AUX has been selected as the input source. * Confirm that playback has started on the external device and the output volume is set appropriately.
What to do if TechniSat Radio cannot be operated?
If your TechniSat Radio cannot be operated, disconnect it from the power supply and then reconnect it.
What to do if the display of TechniSat Radio does not switch on?
If the display on your TechniSat Radio does not switch on, try disconnecting the device from the power supply and then reconnecting it.
Why TechniSat DIGITRADIO 371 CD IR Radio has distorted sound?
If you hear distorted sound from your TechniSat Radio, it might be caused by a mobile phone or other device emitting disruptive radio waves nearby. Try removing the mobile phone or device from the vicinity of the radio.
Why does TechniSat DIGITRADIO 371 CD IR automatically switch to standby?
The auto standby function switches the TechniSat Radio device to standby after approximately 15 minutes if there is no playback in DAB, CD, Bluetooth, or USB modes.
What to do if TechniSat DIGITRADIO 371 CD IR Radio has operational malfunctions?
If you experience other operational malfunctions, loud noises, or a malfunctioning display with your TechniSat Radio, it may be due to malfunctioning electronic components. Remove the mains plug, keep the device separated from the power source for about 10 seconds, and then reconnect the device.
What to do if CD is not detected on TechniSat DIGITRADIO 371 CD IR Radio?
If your TechniSat Radio is not detecting a CD or MP3 CD, or if the music skips during playback, carefully clean the underside of the CD or try using another CD.
Guidelines and warnings for safe operation, maintenance, and handling of the device.
Steps required before operating the DIGITRADIO for the first time.
Guide on how to safely connect the device to a power source.
How to power the DIGITRADIO on and put it into standby mode.
How to choose between different audio sources like DAB, FM, Internet Radio, etc.
Instructions on how to control the audio volume level.
How to tune into and receive DAB+ digital radio stations.
Steps to scan for all available DAB+ stations in the reception area.
How to browse and select stations from the DAB+ list.
How to select and activate FM radio reception.
Scanning for available FM stations automatically.
Browsing and selecting Internet radio stations by category or country.
Enabling the Bluetooth function to connect external devices.
Step-by-step guide to connect smartphones or tablets via Bluetooth.
Instructions on how to insert, play, and control CD playback.
Navigating between tracks on a CD.
How to open the CD tray and remove a disc.
How to play, pause, stop, and navigate music files from a USB device.
Selecting specific tracks or folders on a connected USB device.
Configuration and management of the device's alarm functions.
How to program the alarm time, source, and volume.
Procedure to stop the alarm once it has sounded.
Configuration of network connections and internet-related settings.
Guides for connecting the device to a wireless network via wizard or manual setup.
Setting the device's time and date, and configuring updates.
Step-by-step instructions for manually entering the current date and time.
Procedures for updating the device's firmware.
To Next Page
General