TechniSat DIGITRADIO 52 CD

140
13.4 Factory seings
If you change the location of the device, e.g. when moving house, it is possible that the
saved stations can no longer be received. In this case you can reset the device to factory
seings to delete all the saved stations and then launch a new scan.
> Hold the SELECT/MENU buon down again briefly. Use the < or > buons to
select the [Factory seing] item and press the SELECT/MENU buon.
> To execute the factory seings, use the < [Y] (Yes) buon or use the > [N] (No)
buon to cancel, and press the SELECT/MENU buon
All previously stored stations and seings will now be deleted. The device is now
in the same status as when delivered.
> The display will show [Restart...] and the device will start using the language
selection [Language]. Using the < or > buons, select one of the available
languages and confirm the selection by pressing the SELECT/MENU buon.
The device then automatically performs a complete scan in DAB mode. While
scanning, the display information shows the progress as well as the number of
digital radio stations detected. Aer completing the station scan the first DAB+
channel is played.