73
DE
EN
FR
NL
18.2.2 More information about the network connection
> To find out more about the current connection select Show seings.
> Select Manual seings, if you know your network parameters and you would
like to configure them manually. Take note of the instructions on the display.
> Select Delete network profile, to delete connections no longer required.
> Under NetRemote PIN you can configure a PIN for remote access (e.g. using
the TechniSat CONNECT app).
> Select Allow WLAN connection in standby mode if the WLAN connection
should be retained in standby mode as well. This seing increases power
consumption but enables App control via the TechniSat CONNECT app.
18.3 Time seings
> Press the MENU buon and then select [Main Menu > System Seings >
Time and Date].
> Select [Time/Date Seing] to set the time and date manually.
Use the or buons to select a value. Change it using the or
buons.
> Confirm by pressing OK.
> Select [Update seings] to determine whether the time update should be
automatic via DAB+, FM or Internet or whether you would like to enter it
manually.
> To do this, select [DAB+ update], [FM update], [NETupdate] or [No
update].
> Under the [Set format] option you can activate the 12 or 24 hour format.
Confirm your selection with the OK buon.
> Under [Set time zone], select the current time zone in your location (only for
Internet updating).
> Under [Summertime] you specify whether summertime should currently be
active (only for Internet updating).
18.4 Language
> Press the MENU buon and then select [Main Menu > System Seings >
Language].
> Using or select the language and confirm the selection by pressing OK.
To Next Page
Loading...
Need help?
General