Connect the headset with another Bluetooth device 3.2.
Before you are able to use the Bluetooth device for the rst time together with other
deivces, you have to connect those devices.
As the process can dier from device to device, we will state the principal process in
the following.
After a successful connection a tone time, the devices do remember each other so
going through the whole connection process again every time is not necessary.
The headset is able to store 8 device connections. In case of a connection to an ad-
ditional device, the rst connection will be deleted.
After switching on the headset the last Bluetooth connection will be reconnected
automatically.
If you like to use another device, please deactivate the Bluetooth mode in the de- >
vices you do not want to be connected anymore.
Activating the connection mode 3.2.1.
Please assure that your headset is > switched o.
Press the > MFT for 6 seconds.
The LED glows by turns in red and blue. With that the headset is ready to be connect-
ed to another device.
This mode stays active for approx. 2 minutes in case there will be no connection in-
stalled to another device, the headset switches o automatically.
Connection to another Bluetooth-device 3.2.2.
To connect to another Bluetooth device, please proceed as follows:
to minimize connection failures, please place the dedicated device within 1m to the >
headset
activate the > connection mode at the headset as described in point 4.2.1.
activate the Bluetooth function at the dedicated device and start searching for >
other available devices.
Please choose “ > StereoManBT” from the list of all available devices.
If you are not asked to enter a PIN please use the standard PIN “0000” (not needed >
in case Bluetooth device is supporting V2.1).
Please conrm the connection on your Bluetooth device; when the connection is >
set up the LED is ashing 2 times every 4 seconds.
In case the connection does not work, please switch your headset o and try again
using point 4.2.2.
Set-up a connection to multiple Bluetooth devices 3.2.3.
The StereoManBT enables the connection to up to maximum 2 devices at the same
To Next Page
Loading...