35
DE
EN
FR
IT
NL
PL
Aaching:
Insert the dust holder into the motor unit from above. Make sure that the
catch on the dust holder fits into the corresponding recess in the motor unit
(A). The dust container must engage audibly (B).
A
B
7 First use
Please note the following points before using the device for the first time:
> Remove any films, stickers or transport protection from the device. Never
remove the type plate or any warning labels!
> Charge the baery.
> Set up the storage holder.
7.1 Charging the baery
Before using for the first time, fully charge the baery to reach the maximum
charge capacity. If the baery is discharged during use, it should be fully
recharged before next use.
Connect the power supply only to a properly installed socket that complies
with the technical specifications of the device. The socket must also be
easily accessible aer connection so that the mains connection can be
disconnected quickly.
Before inserting the baery, check that the contacts are clean, and clean
them if necessary.
The baery can be charged separately, when connected to the motor unit
or when in the storage holder. The storage holder has a slot for the mains
adapter DC connector.
To Next Page
Loading...