TechniSat TECHNIMAX AS1

40
WARNING
Risk of injury!
Do not aempt to repair an electrical device yourself.
In the event of defects, always contact the service department (“4.5 Service
information” on page 31).
Problem Possible cause Solution
The device only
operates slowly or does
not start.
The baery is flat. Charge the baery.
The baery is not
charging.
Lower voltage at 0-10
% and 90-100 % to
protect the baery.
Baery protective
circuit.
The suction power is
too weak.
The baery is too
weak.
Charge the baery.
The dust holder is
overfilled.
Empty the dust holder.
The filters are
contaminated.
Clean the filters.
The suction opening is
blocked.
Switch o the device
and remove the
blockage.
Particles that are too
large or heavy can
stick to the carpet.
Remove these foreign
bodies
by hand.
Dust is escaping from
the device during
vacuuming.
The dust holder or
filter are not seated
correctly.
Correct the position of
the dust holder
and filter.
Ensure that the
dust holder is closed.
The filters are
contaminated.
Clean the filters.
The filters are worn
out or damaged.
Replace the filters.