EN6
Initial operation:
` Open the Weather Station battery compartment cover
` Insert 2 x AAA batteries observing polarity [ “+” and “ –“ marks]
` When you insert the batteries, all icons on the LCD display will light up for 3 seconds, you
will hear a beep tone and the station detects indoor temperature & humidity.
` The Weather Station will now start to make a connection to the outdoor remote sensor.
This operation takes about 3 minutes and is displayed by a flashing reception RF
antenna symbol in the “OUTDOOR” display area on the receiver.
` Open Wireless Outdoor Sensor battery compartment cover, Insert 2 x AA batteries
observing polarity [ “+” and “–“ marks].
` After receiver has created a connection to the outdoor remote sensor, After 3 minutes it
will enter the Radio control time receive mode.
Reception of the DCF signal:
` The clock will automatically search the DCF (radio controlled time) signal after 3 minutes
of any restart or changing of new fresh batteries. The radio mast icon starts to flash.
` At 1:00 /2:00 / 3:00 am, the clock automatically carries out the synchronization procedure
with the DCF signal to correct any deviations to the exact time. If the synchronization
attempt is unsuccessful (the radio mast icon disappears from the display), the system will
automatically attempt another synchronization at the next full one hour. This procedure is
repeated automatically up to total 5 times.
` To start manual DCF signal reception, press and hold the “ ” button for 3
seconds. If no signals received within 7 minutes, then the DCF signal search stops (the
radio mast icon disappears) and start again at the next full one hour.
To Next Page
Loading...
Need help?
General
