Techno HDS Series - Safety Information; General Safety Instructions and Precautions

4
For Support Visit· support.technocnc.com or Call: (631) 648-7481
HDS User Manual
(HTT06291133)
1.2 SAFETY INFORMATION!
1. Keepngers,hands,andallotherobjectsawayfrom
machine while power is on.
2. Disconnect power to all system components when
not in use, when changing accessories, and before
servicing.
3. Donotloosen,remove,oradjustmachinepartsor
cables while power is on.
4. Exercise care with machine controls and around
keyboard to avoid unintentional starting.
5. Make sure voltage supplied is appropriate to
specicationsofcomponents.
6. Machines must be plugged into four-pronged
grounded outlets. Do not remove the grounding
plug or connect into an ungrounded extension cord.
7. Keep cables and cords away from heat, oil, and
sharp edges. Do not overstretch or run them under
otherobjectsoroverworksurfaces.
8. Useproperxturesandclampstosecurework.
Never use hands to secure work.
9. Do not attempt to exceed limits of machine.
10. Do not attempt to use machine for purposes other
than what is intended.
11. Use machine only in clean, well-lit areas free from
ammableliquidsandexcessivemoisture.
12. Stay alert at all times when operating the machine.
13. Always wear safety goggles.
14. Donotwearjewelryorloose-ttingclothingwhen
operating machine. Long hair should be protected.
15. Always maintain proper balance and footing when
working around the machine.
16. Maintainequipmentwithcare.Keepcuttingtools
clean and sharp. Lubricate and change accessories
when necessary. Cables and cords should be
inspected regularly. Keep controls clean and dry.
17. Before using, check for damaged parts. An
authorized service center should perform all repairs.
Only identical or authorized replacement parts
should be used.
18. Removeanyadjustingkeys and wrenches before
turning machine on.
19. Do not operate the machine unattended.
20. Follow all safety instructions and processing
instructions in the MSDS for the material being
processed.
21. Use proper precautions with dust collection systems
topreventsparksandrehazards.
22. Makesuretohaveproperreextinguishing
equipmentonhandatalltimes.
Read these instructions thoroughly before operating
machine. DO NOT operate machine if you are unfamiliar with
these safe operating instructions. DO NOT operate machine
without knowing where the emergency stop switch is located.
PREVENT FIRE HAZARDS by using the proper feeds, speeds, and tooling while operating your Techno machine.
For example, setting feeds and speeds too low and/or using dull tool bits creates friction at the material.
The friction generates heat which can result in a re that can be drawn through the vacuum table or dust
collector without warning. Fire hazard from friction heating caused by dull tools is possible when cutting certain
materials, especially composite material such as wood composites, MDF and Particleboard. © 2015