Techno HDS Series User Manual

For Support Visit· support.technocnc.com or Call: (631) 648-7481
1
HDS User Manual
(HTT06291133)
This manual will provide unpacking, maintenance, and user
guide for running the Techno HDS Series CNC Router.
It is suggested that the operator keep this manual by the
machine. This will provide the most important information
pertaining to the operation of this machine.
©2017 (05/08/2017)
WARNING: DO NOT OPERATE THIS MACHINE WITHOUT PROPER
TRAINING! Improper or unsafe operation of the machine will result
in personal injury and/or damage to the equipment.

Techno HDS Series Specifications

General

Brand	Techno
Model	HDS Series
Category	Power Tool
Language	English

Summary

General Installation Instructions

Unpacking and Machine Identification

Instructions for unpacking and identifying machine components.

Forklift Guide and Safety Procedures

Measuring forks, lifting procedures, and safety warnings for machine movement.

Safety Information

General Safety Instructions and Precautions

Comprehensive safety instructions and precautions for operating the machine.

Collet Setup and Safety Guidelines

Correct Colleting Procedure

Proper assembly and usage guidelines for collets to prevent spindle damage.

Spindle Setup and Operation

HSD Spindle Warmup Procedure

Procedure for warming up the spindle before operation for optimal performance.

Electrical and Pneumatic Connections

Connection Guide for Power and Air

Instructions for connecting electrical power and pneumatic air supply.

Vacuum Pump Connections

Vacuum Pump Connection Procedure

Step-by-step guide for connecting the vacuum pump to the machine.

Machine Start-Up and Interface

Start-Up Procedure

Step-by-step guide for powering on and starting the machine.

Software Initialization

Instructions for starting the machine's control software.

Interface Overview

Overview of the initial machine interface screen and basic operations.

Machine Interface and Controls

Screen Layout and Elements Overview

Explanation and labeling of the main interface screen elements.

Jogging and Homing Operations

Using the jogging and homing functions for machine movement.

Origin Setup and Management

How to apply, go to, and save origins for part positioning.

Tool and Offset Management

Managing tool offsets, identification, and changes.

File System and Network Configuration

File Transfer and Management

How to transfer G-code files to the controller's network drive.

Operating Tutorials

Jogging the Machine

How to control machine movement using different jog modes.

Learning Tool Lengths

Procedure for measuring and inputting tool lengths for accurate machining.

Saving XYZ Zero Position

Steps to set the origin (XYZ zero position) for part machining.

Preparing and Running G-Code Files

How to prepare G-code files and execute them on the machine.

Advanced Machine Operations

Block-to-Block Functionality

Running specific sections of G-code files.

Memory Search and Profile Return

Finding last reset points and returning to part profiles.

Setup Parameters Configuration

Adjusting parameters like jog step size and other settings.

Parameter Backup and Restore

Backing Up Machine Parameters

Procedures for backing up Amp and PLC parameters.

Restoring Machine Parameters

Steps to restore saved parameters after rebooting in setup mode.

Machine Lubrication

Lubricating Drive Components

How to lubricate the X-Y rack, pinion, and Z-axis ballscrew.

Recommended Lubricants

List of recommended grease and oil for machine lubrication.

Appendix and Addenda

HSD Aggregate Tool Setup

Instructions for properly installing and setting up HSD aggregate tools.

Setting Drill Lengths

How to set up drill lengths for the drill bank machine.

Service and Maintenance Schedule

Guidelines for routine maintenance of machine components.

Fault Finding and Error Codes

Common problems, error messages, and their solutions.